no need gai.conf because I no longer prefer ipv4

1 files changed, 0 insertions, 65 deletions

diff --git a/etc/gai.conf b/etc/gai.conf
deleted file mode 100644
index 4616ed00..00000000
--- a/etc/gai.conf
+++ /dev/null
@@ -1,65 +0,0 @@
-# Configuration for getaddrinfo(3).
-#
-# So far only configuration for the destination address sorting is needed.
-# RFC 3484 governs the sorting.  But the RFC also says that system
-# administrators should be able to overwrite the defaults.  This can be
-# achieved here.
-#
-# All lines have an initial identifier specifying the option followed by
-# up to two values.  Information specified in this file replaces the
-# default information.  Complete absence of data of one kind causes the
-# appropriate default information to be used.  The supported commands include:
-#
-# reload  <yes|no>
-#    If set to yes, each getaddrinfo(3) call will check whether this file
-#    changed and if necessary reload.  This option should not really be
-#    used.  There are possible runtime problems.  The default is no.
-#
-# label   <mask>   <value>
-#    Add another rule to the RFC 3484 label table.  See section 2.1 in
-#    RFC 3484.  The default is:
-#
-#label ::1/128       0
-#label ::/0          1
-#label 2002::/16     2
-#label ::/96         3
-#label ::ffff:0:0/96 4
-#label fec0::/10     5
-#label fc00::/7      6
-#label 2001:0::/32   7
-#
-#    This default differs from the tables given in RFC 3484 by handling
-#    (now obsolete) site-local IPv6 addresses and Unique Local Addresses.
-#    The reason for this difference is that these addresses are never
-#    NATed while IPv4 site-local addresses most probably are.  Given
-#    the precedence of IPv6 over IPv4 (see below) on machines having only
-#    site-local IPv4 and IPv6 addresses a lookup for a global address would
-#    see the IPv6 be preferred.  The result is a long delay because the
-#    site-local IPv6 addresses cannot be used while the IPv4 address is
-#    (at least for the foreseeable future) NATed.  We also treat Teredo
-#    tunnels special.
-#
-# precedence  <mask>   <value>
-#    Add another rule to the RFC 3484 precedence table.  See section 2.1
-#    and 10.3 in RFC 3484.  The default is:
-#
-#precedence  ::1/128       50
-#precedence  ::/0          40
-#precedence  2002::/16     30
-#precedence ::/96          20
-#precedence ::ffff:0:0/96  10
-#
-#    For sites which prefer IPv4 connections change the last line to
-#
-#precedence ::ffff:0:0/96  100
-
-#
-# scopev4  <mask>  <value>
-#    Add another rule to the RFC 6724 scope table for IPv4 addresses.
-#    By default the scope IDs described in section 3.2 in RFC 6724 are
-#    used.  Changing these defaults should hardly ever be necessary.
-#    The defaults are equivalent to:
-#
-#scopev4 ::ffff:169.254.0.0/112  2
-#scopev4 ::ffff:127.0.0.0/104    2
-#scopev4 ::ffff:0.0.0.0/96       14