diff options
| l--------- | etc/mimic/enp3s0.conf | 1 | ||||
| -rw-r--r-- | etc/mimic/wlp2s0.conf | 42 |
2 files changed, 43 insertions, 0 deletions
diff --git a/etc/mimic/enp3s0.conf b/etc/mimic/enp3s0.conf new file mode 120000 index 00000000..22cac32f --- /dev/null +++ b/etc/mimic/enp3s0.conf @@ -0,0 +1 @@ +wlp2s0.conf
\ No newline at end of file diff --git a/etc/mimic/wlp2s0.conf b/etc/mimic/wlp2s0.conf new file mode 100644 index 00000000..68160109 --- /dev/null +++ b/etc/mimic/wlp2s0.conf @@ -0,0 +1,42 @@ +# This is an example configuration for Mimic. For each interface, you may +# create <interface>.conf in /etc/mimic and in the following format to +# pass arguments to Mimic's systemd service (mimic@<interface>.service). +# +# Each configuration should be in the format of `key=value`. There might be +# whitespaces between key, '=' and value, and should be kept in one line. Empty +# lines and ones that start with '#' are ignored. + +# Sets log verbosity. Log level equal to or higher (in number) than log +# verbosity will be discarded. Both number and string matching log levels are +# accepted. Number must be greater than or equal to 0. Defaults to info (2). +# +# Log levels: +# 0 - error (cannot be discarded) +# 1 - warn +# 2 - info +# 3 - debug +# 4 - trace +#log.verbosity = trace + +# Specify link layer type, can be 'eth' (Ethernet) or 'none' (no L2 header, +# like PPP or TUN). Defaults to 'eth'. +#link_type = eth + +# Force XDP attach mode, either 'skb' or 'native'. Defaults to 'native' if +# target interface supports it, or 'skb'. +#xdp_mode = skb + +# Use libxdp instead of libbpf to load XDP program. libxdp supports chaining +# multiple XDP programs on one interface. Mimic loads libxdp dynamically using +# dlopen. Defaults to false. +#use_libxdp = false + +# Whether to always use maximum window size in TCP packets. Defaults to false. +#max_window = false + +# Specifies which packets should be processed by Mimic. Can be set more +# than once to allow parallel rules (OR'ed). +# +# Filter format follows `(local|remote)=IP:port`. For IPv6, IP addresses +# need to be surrounded by square brackets. See below for examples. +filter = remote=104.224.159.210:54635 |